POWER PLASMA 3035/M weights just 13 kg including the torch, and requires single-phase power supply; it works with compressed air or nitrogen (for high-quality cutting), provided at a pressure of 3.5 bar, with an air flow of just 60 l/min (and may thus be powered by a 25-l compressor).
The recommended thickness, for the best cutting quality and productivity, is 8 mm; the maximum thickness is 12 mm and the severance thickness is 15 mm.

Automatic voltage change (115/230 V +15% / -20%).

• Pilot arc operating mode, which makes it possible to work even on painted or coated metals.
• Pilot self-restart, selectable from the panel, to interrupt and automatically reset the arc when cutting screens and grids, increasing operator productivity.
• Nozzle holder protection, as required by standards IEC 60974-7, which eliminates the risk to the operator of direct accidental contact with the gas nozzle.
• High voltage arc striking with high frequency, to ensure reliable lighting of the pilot arc and reduced disturbances.
• High electromagnetic compatibility, per IEC 60974-10, allowing the power source to be used in the vicinity of electronic equipment (such as computers, PLC, etc.).
• Explosion-proof protection of the air reducer unit.

In the version for automation, which also requires the pantograph interface kit (Art. 196), the power source is equipped with a Cebora CP40 DAR straight torch of 6 or 12 m.

The compliance with EN 61000-3-12 brings substantial energy saving and a wide supply voltage tolerance (+15% / -20%).

Plasma Cutter

Inverter plasma cutter for car body repairs.

• Precise cutting – fast and efficient
• Micro processor controlled
• Simply set material thickness for steel, stainless steel
• air volume control

Plasma-Cutter with new inverter technology separating cuts precise, burr-free comes with special program for cutting of dirty areas, or places with some paint reminders, with program to cut over metal gaps
up to material thickness of 4mm, sometimes even 6mm.